Monnit Serial MODBUS Betriebsanweisung

Information to UsersThis equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant to Part 15 of the FCC R

Temperature DATA_0: INT16, SIGNED. Data is recorded in Celsius. Divide data by 10 to get degrees Celsius out to one decimal point. Example: Data=271.

TroubleshootingIf you cannot talk to the Serial MODBUS Gateway, please double check the following:Verify the voltage on the red wire interfaced to our

For additional information or more detailed instructions on how to use your Monnit Serial MODBUS Gateway or Monnit Wireless Sensors, please view our s

PAGE 2Features• Works with Monnit 900, 868 and 433MHz Sensor Networking Solutions• Communicates with MODBUS RTU / ASCII Protocols• Supports RS-232

Connecting to the Serial MODBUS Gateway 1. Connect Antenna2. Use communication select jumper to set RS-485 or RS-232C3. Connect wires from MODBUS to S

Verify Communication SettingsThe Serial MODBUS supports 2 transmission modes: RTU and ASCII. The default communication is MODBUS-RTU, 8 data bits, No

Register Name Address DescriptionBAUDRATE 40007 Designates the baud rate used by the MODBUS interface. After moding this register, a gateway reset m

Register Sensors To SMG DO NOT INSERT BATTERIES UNTIL SENSOR HAS BEEN REGISTERED. In order for the Serial MODBUS Gateway to go active, you will need

Then actuate this coil to verify that the ID and CODES were input correctly and to add the wireless device. If successful, the coil write will also b

WD_CNT 40004 Wireless Device Count – Value that can be read to discover the number of registered sensors are congured to operate on the gateway. A v

Poll the DATA_READY coil @ address 2. If it returns true, there is sensor data ready to view.Read / Interpret Sensor DataThe actual data delivered by